
Chimney flashing repairs in Burgess Hill. We refix or replace the lead that seals your chimney to the roof, one of the most common causes of leaks, with no call-out charge and free quotes.
Flashing is the weatherproof seal, usually lead, around the base of the chimney where it meets the tiles. It's made of several parts: an apron at the front, stepped pieces down the sides and a back gutter behind. Together they direct rain away from the joint.
Lead can split with age, lift in strong winds or come loose when the mortar holding it into the brickwork wears away. Older repairs made with sealant or mortar fillets often crack too. Any gap lets rain run straight down into the loft beside the chimney.
If the lead is in good condition but has come loose, it can be dressed back down and repointed into the brick joints. If it's split, thin or badly fitted, new lead flashing is the lasting fix. We'll show you which your chimney needs and why.
We inspect the flashing from the roof and look at the timbers and felt around the chimney from the loft, where water stains show where it has been getting in. You then get a free quote, explaining whether the existing lead can be refixed or needs replacing.
To replace flashing, we remove the old lead and any sealant, cut fresh joints in the brickwork, then fit new lead pieces shaped to the chimney and the tiles. The lead is wedged and pointed into the joints. We check the tiles around the chimney and replace any damaged ones.
Tell us about the leak, the damage or the job you have in mind. We aim to respond the same day.
We look at the roof, explain what we find and give you a free, no-obligation quote before any work starts.
We carry out the repair or installation, then test and check the finished work before we leave.
If the damp is next to the chimney breast, on the ceiling beside it or on the timbers around the stack in the loft, failed flashing is a likely cause. It's one of the most common sources of roof leaks. We can inspect it and tell you for sure.
Sealant can buy some time, but it isn't a lasting repair. It cracks and comes away as the weather heats and cools the joint. Properly fitted lead flashing, set into the brick joints, lasts far longer. We'll refix or replace the lead rather than relying on sealant.
Well-fitted lead flashing can last for many decades. It usually fails because the pointing holding it in place erodes, or because it was fitted in pieces that were too long. Checking it every few years and repointing the joints when needed keeps it working much longer.
On a typical chimney, new lead flashing can usually be fitted in a day once safe access is in place. Larger stacks or chimneys with a back gutter to rebuild may take a little longer. We'll give you a timescale with your quote.
We repair chimney flashing in Burgess Hill and these nearby areas.
We also offer:
Water showing up beside your chimney? Call us and we'll check the flashing and give you a free quote.