
Chimney leak repairs in Burgess Hill for damp chimney breasts, stained ceilings and water in the loft. We find how the water is getting in and fix it at the source, with 24/7 call-outs.
Chimney leaks usually come through failed flashing where the stack meets the roof, porous or cracked brickwork, a broken crown or flaunching on top, or an open pot with no cap letting rain fall straight down the flue. Each one needs a different repair.
Not every damp chimney breast is a leak. A capped-off flue with no airflow can collect condensation, and old soot deposits can draw moisture into plaster, leaving brown stains. We check for these too, so you get the right fix rather than an unnecessary roof repair.
Water getting into a chimney soaks the brickwork, then the plaster and timbers around it. Left alone, it can rot joists, spoil decorations and weaken the stack as frost gets into wet bricks. A prompt repair stops the damage spreading further.
We ask where the damp is showing and when it appears, then inspect the chimney outside and from the loft. Damp that shows only in driving rain points to different causes than damp that's there all the time. Once we've found the source, you get a free quote for the repair.
The repair might be new lead flashing, fresh flaunching, repointing, a cap or cowl on an open pot, or a combination. If water is coming in during bad weather, we can make a temporary repair first. Afterwards, we explain how long the wall may take to dry before redecorating.
Tell us about the leak, the damage or the job you have in mind. We aim to respond the same day.
We look at the roof, explain what we find and give you a free, no-obligation quote before any work starts.
We carry out the repair or installation, then test and check the finished work before we leave.
The most common causes are rain getting in through failed flashing, porous brickwork or a cracked crown, or rain falling down an uncapped flue. Condensation in a sealed flue and old soot salts can also cause damp patches. We inspect the chimney to find which one is affecting yours.
Yes. We offer 24/7 emergency call-outs across Burgess Hill and nearby. If water is pouring in, we can usually make a temporary repair or cover to stop it, then return in dry weather to carry out the permanent fix on the flashing, brickwork or crown.
It depends on how wet the brickwork got and how long it was leaking. A small damp patch may dry in a few weeks, while a stack that has been wet for months can take much longer. It's best to wait until the wall is fully dry before replastering or redecorating.
A cowl or cap stops rain falling straight down the flue, which is a common cause of damp in disused chimneys. It won't fix water getting in through flashing or brickwork. We'll check the whole chimney so you know whether a cowl alone will solve the problem.
We stop chimney leaks in Burgess Hill and the nearby villages listed here.
We also offer:
Damp around your chimney breast? Ring us and we'll track down where the water is getting in.