Chimney Repointing in Burgess Hill
Chimney repointing in Burgess Hill. We rake out worn mortar and refill the joints to keep rain and frost out of your chimney, with free, no-obligation quotes and no call-out charge.
- No call-out charge
- Free, no-obligation quotes
- Same day response
- 24/7 emergency call-outs
Chimney repointing in Burgess Hill
- 01
Why mortar wears away
Mortar is softer than brick by design, so it takes the wear instead of the bricks. After years of rain, wind and frost, it erodes and leaves the joints recessed or empty. Once that happens, water soaks into the stack instead of running off it.
- 02
Choosing the right mortar
Many older chimneys were built with lime mortar, which lets the brickwork breathe. Refilling them with hard cement mortar can trap moisture and damage the bricks. We match the mortar to your chimney's age and brick type, as well as its colour.
- 03
Repointing or rebuilding
Repointing works when the bricks are sound and the stack is straight, with only the mortar worn. If bricks are cracked through, crumbling, or the chimney leans, repointing alone won't make it safe. We'll tell you which your chimney needs after looking at it.
What to expect from chimney repointing
We inspect the chimney to check that the bricks are sound and the stack is straight, and to see what mortar was used originally. Your free quote covers the repointing, any brick replacements and the access needed. We then book a dry spell, as fresh mortar needs to set without heavy rain.
With access in place, we rake out the old mortar to a good depth and brush the joints clean. Fresh mortar is pressed in firmly and finished to suit the brickwork. We check the flashing and flaunching while we're up there and let you know if either needs attention too.
What's included
- Brickwork and stack checked first
- Old mortar raked out to depth
- Mortar matched to the chimney
- Joints filled and finished neatly
- Flashing and flaunching looked over
- Debris cleared away
How it works
Call or send a message
Tell us about the leak, the damage or the job you have in mind. We aim to respond the same day.
We inspect and quote
We look at the roof, explain what we find and give you a free, no-obligation quote before any work starts.
Work done and checked
We carry out the repair or installation, then test and check the finished work before we leave.
Chimney repointing questions
How do I know if my chimney in Burgess Hill needs repointing?
If the mortar between the bricks is recessed, crumbly when touched, missing in places or has plants growing from it, the chimney likely needs repointing. Damp on the chimney breast inside can also be a sign. We can check from the ground and close up to confirm.
How often does a chimney need repointing?
Good repointing can last for many years, often decades, depending on how exposed the chimney is and the mortar used. Stacks on the windward side of a roof usually wear faster. Checking the chimney every few years, or after storms, helps catch worn joints early.
Can you repoint a chimney with lime mortar?
Yes. On older chimneys built with lime mortar, we repoint with a suitable lime mix so the brickwork can still breathe and dry out. Using hard cement mortar on these chimneys can trap moisture and damage the bricks, so we match the mortar to the original.
Does repointing stop a chimney leaking?
It stops water getting in through worn mortar joints, which is a common cause of chimney damp. If the leak is coming through failed flashing, a cracked crown or an open pot, those need fixing as well. We check every part of the stack so the leak is properly dealt with.
Chimney repointing around Burgess Hill
We repoint chimneys in Burgess Hill and the nearby areas below.
Other chimney services in Burgess Hill
- Chimney Repairs
- Chimney Leak Repairs
- Chimney Rebuilding
- Chimney Stack Removal
- Chimney Flashing Repairs
- Chimney Pot Replacement
- Chimney Cowl Fitting
We also offer:
Book chimney repointing in Burgess Hill
Mortar crumbling out of your chimney? Call us or send a photo for a free repointing quote.